* Fix issues with SFN entries sometimes being treated as LFNs
see https://github.com/raspberrypi/rpi-eeprom/issues/514
* Add a dedicated message for "M.2 HAT" not being found instead of
the generic 'unsupported boot order' message when NVMe boot is
skipped.
* Fix an issue where the boot partition parameter in PM_RSTS was cleared
before being checked.
https://github.com/raspberrypi/firmware/issues/1853
* Add a specific fatal error pattern for RP1 not found - 4 long - 3 short
* Initialise the DWC PHY to enable DWC host+peripheral support under Linux.
Requires 82069a7a02
* Force PWM on 3V3 supply if cameras or HATs are connected or if
power_force_3v3_pwm=1 in config.txt
Resolves an image quality issue with the GS camera.
* Add support for C(arm_min_freq) < 1500 MHz (must be at >= 200 MHz)
* Manufacturing test updates for DVFS.
* Add autodetect support for PCIe expansion HATs
* Add PCIE_PROBE=1 to the EEPROM config for custom PCIe exapansion
designs that do not support the upcoming HAT spec. This gives
similar behaviour to CM4 where PCIe x1 is enumerated to discover NVMe
devices.
* Fix loading of multiple initramfs images that are not 32-bit aligned sizes
https://github.com/raspberrypi/firmware/issues/1843
* Kernel load performance improvement - remove a memcpy
* Fix SDIO / WiFi clock-setup for BOOT_ORDER=0xf14
* Fix SD power-on-reset
* Firmware support for improved watchdog driver
* Update DHCP Option97 to be R,P,i,5 on Pi5
* Add support for HAT gpiomap for improved HAT compatibility.
* Add I2C probe for DSI display auto detect
* Automatically set dtparam=nvme if booted from nvme
* Fix network boot reset issue where only the first attempt works.
* Adding pciex4_reset=0 to config.txt will leave RP1 PCIe enabled when
ARM stage is started.
* Prevent HDMI diagnostics being displayed immediately when waking
after HALT.
* Update board-name - "Rasberry Pi 5"
