mirror of
https://github.com/raspberrypi/rpi-eeprom.git
synced 2026-01-20 21:13:36 +08:00
96349fe65c
* net-install: Fix keyboard detection on hubs * recovery: Always enable UART debug output on 2712 * Set POWER_OFF_ON_HALT defaults The default value for POWER_OFF_ON_HALT on CM5 and Pi 500 will be 1. Pi5 defaults to 0 for backwards compatibility. * boot-time: Remove unnecessary 1 second delay when configuring DWC2 controller. * Enable initial_turbo=60 by default This reduces the time to get load and decompress the kernel. * logging: Remove superfluous newline on SDRAM refresh changed messages * Fix initial_turbo duration The timeout counter for the previous implementation could run too quickly causing the initial-turbo timeout to end earlier than expected. * rp1-fw: Add the mailbox firmware interface, and PIO support that uses it. * rp1-fw: Turn off unused 25MHz Ethernet refclk
rpi-eeprom
This repository contains the scripts and pre-compiled binaries used to create the rpi-eeprom package which is used to update the Raspberry Pi 4 and Raspberry Pi 5 bootloaders EEPROM images.
Support
Please check the Raspberry Pi general discussion forum if you have a support question.
Reset to factory defaults
To reset the bootloader back to factory defaults use Raspberry Pi Imager to write an EEPROM update image to a spare SD card. Select Misc utility images under the Operating System tab.