* Adjust the SDRAM refresh interval based on the temperature. This
addresses the gap in performance between the 8GB and 4GB variants.
See https://github.com/raspberrypi/firmware/issues/1854
* Preliminary support for signed boot
* Fix issues with SFN entries sometimes being treated as LFNs
see https://github.com/raspberrypi/rpi-eeprom/issues/514
* Add a dedicated message for "M.2 HAT" not being found instead of
the generic 'unsupported boot order' message when NVMe boot is
skipped.
* Fix an issue where the boot partition parameter in PM_RSTS was cleared
before being checked.
https://github.com/raspberrypi/firmware/issues/1853
* Add a specific fatal error pattern for RP1 not found - 4 long - 3 short
Add NVMe into the SD/USB/DEFAULT boot modes with a higher
priority than USB. The detection of NVMe HATs is quick so
there is no disadvantage in trying NVMe first.
* Initialise the DWC PHY to enable DWC host+peripheral support under Linux.
Requires 82069a7a02
* Force PWM on 3V3 supply if cameras or HATs are connected or if
power_force_3v3_pwm=1 in config.txt
Resolves an image quality issue with the GS camera.
* Add support for C(arm_min_freq) < 1500 MHz (must be at >= 200 MHz)
* Manufacturing test updates for DVFS.
Enforcing package checksum validation makes it difficult to install
new EEPROM binaries via rpi-update causing extra churn of APT releases.
Drop this check by default because random corruption of these files
either via software or users never actually happens.
* Add autodetect support for PCIe expansion HATs
* Add PCIE_PROBE=1 to the EEPROM config for custom PCIe exapansion
designs that do not support the upcoming HAT spec. This gives
similar behaviour to CM4 where PCIe x1 is enumerated to discover NVMe
devices.
* Fix loading of multiple initramfs images that are not 32-bit aligned sizes
https://github.com/raspberrypi/firmware/issues/1843
* Kernel load performance improvement - remove a memcpy
On Raspberry Pi 5 there are dedicated pins for the bootloader SPI
EEPROM. This makes it possible to do immediate updates via flashrom.
The "current" EEPROM config is the EEPROM config at boot rather
than what has just been written to the SPI flash because this is
consistent with current behaviour.
To use flashrom instead of recovery.bin for bootloader updates
set RPI_EEPROM_USE_FLASHROM=1 in /etc/defaults/rpi-eeprom-update
BCM2711
On CM4, Pi4, CM4-S, Pi400 config.txt must be modified to disable
the analog audio driver which shares the GPIO pins used by the
bootloader EEPROM.
dtparam=spi=on
dtoverlay=audremap
dtoverlay=spi-gpio40-45
* Fix SDIO / WiFi clock-setup for BOOT_ORDER=0xf14
* Fix SD power-on-reset
* Firmware support for improved watchdog driver
* Update DHCP Option97 to be R,P,i,5 on Pi5
The Pi5 EEPROM is larger and can take longer to update which
slightly increases the change of failure if the board power is
disconnected across an update. Re-enable recovery.bin for SD
updates for now.
